Step 11 : SSR's for the 64 Channel Controller

This is a layout to make 16 SSR's from one stripboard. I had a layout for 24 but it was just too tight. You can cut these out for any grouping you need and they can be used with a sink or source.
I haven't found an easy way to mount RJ45 jacks to a stripboard so you may have to use your imagination... solder to the board and Keystone Jacks (expensive!) or wire nuts? ;-)
It may be a good idea to remove all of the unused copper around the opto's and 110Vac side of the board.