|
|
HowTo: Compact 4 Port SSR Box
( Frank Kostyun)
Step 5 : Install Into the Electtrical Box
|
| | I use a cheap 15' two prong extension cord to provide power to each box. I cut the end off at about 1', and install that end though the box. This allows to chain controllers together as one "long" extension cord.
Solder the power wire into the circuit board, and then attach a crimp on connector on the other end, and then bolt the circuit board into the box.
The relays are installed and mounted into the electical box.
I have also found that I if I tilt the board a little bit up on the left, that it fits together better.
|
|
|
