HowTo: a simple control box for a 32 channel 595 controller
(
erik hodgson)
Step 2 : save to save
|
| |
NOTE: THE BOARD SHOWN IN THIS STEP IS THE NETWORK SWITCH BOARD...NOT THE 595
In my case i am using the led's and the rj-45 jacks. I am cutting the board into three pieces. I cut the board on the yellow lines in the pic. the first piece is where the RJ-45 jacks are mounted. The next piece is section that the leds are mounted. the reason i am keeping the board intact where these parts mount is so they will fit into the case. As the led's are inside plastic fittings that match up with the case. the middle section of the board is discarded or used for spare parts.
|
