HowTo: Non Permanent 200a power panel
(
Patrick Sullivan)
Step 4 : Assembly
|
| |
first layout the panel and the boxes with the connectors in them lossely on the plywood trying to center it left to right and making it flush on the bottom this is so that the panel will stand up on its own as in the picture
once you have it where you want it screw the panel down first
then tighten down all the connectors
and finally screw down the boxes starting with the one that attaches to the panel
**NOTE**
after finishing this and putting the cover on the one that I made and i forgot that the cover goes down about 1/2 further then the box so when you fit the panel on do it with the cover on
|
